FAQ: How To Remove Plastic Auto Body Fasteners?

What tool should be used to remove plastic trim fasteners?

Body Clip Pliers These specially designed & patented pliers will remove any clip found on trim, bumpers, etc. Steel levers enclosed in plastic handles; prevent scratches & nicks in paint.

How do you get a push nut off?

One way to remove a push nut is by inserting the top of a sharp flathead screwdriver or a chisel between the teeth of the push nut and the bolt. Pry the teeth of the push nut up until they bend or break, allowing the push nut to be removed from the bolt.

How do you remove an e clip?

E-clips are large retaining rings, and retaining rings hold parts onto a shaft when installed into a groove. To remove an E-clip, use either a remover tool, needle-nose pliers, or a small, flathead screwdriver. Grasp the E-clip with your tool and push it upwards using moderate pressure.

How do you remove a rolled pin?

Set the convex end of the pin punch into the end of the roll pin. If the roll pin is damaged or has been snapped in half, do your best to align the pin punch so it won’t slip off of the pin as you hammer it. Then, give the end of the punch 2–3 gentle taps with a hammer to loosen it up in its housing.

You might be interested:  FAQ: How To Remove Yellowing From White Plastic?

How do I remove the outside panel of my car?

How to Replace Auto Body Panels

  1. Remove the old or damaged auto body panel. Reach the panel by looking under the vehicle and removing the plastic protective skirting using a Phillips screwdriver.
  2. Look behind the panel and locate the bolts that are holding it to the car.
  3. Pull the old panel off of the car.

Leave a Reply

Your email address will not be published. Required fields are marked *