FAQ: How To Remove Slats From Levelor Plastic Blinds?

Can you remove slats from Levolor blinds?

Using a few simple tools, you can remove slats to shorten blind length. Levolor blinds can be adjusted to window length by removing a number of slats from the bottom of the blinds. Using a few simple tools, you can remove slats to shorten blind length and tailor these stylish blinds to your window size.

Can you remove slats from cordless blinds?

Carefully cut the slats through the holes (including the marked slat) to remove the slats from the blind. Then cut ONLY the outer ladder string. (Do NOT to cut the inner cord, or the blind will be broken) Leaving two ladders, one to insert the bottom rail and one to tuck inside the hole.

How do you adjust the tension on Levolor cordless blinds?

Tighten the loose spring tension:

  1. Bring down the shade to the halfway point.
  2. Detach the roller from the brackets.
  3. Use your hand to roll up the shade but make sure the shades is evenly rolled on the tube.
  4. Replace the roller in the brackets.
  5. Repeat the process until you get the right amount of tension.

How much can you shorten Levolor blinds?

Levolor makes a ready-made cordless (cord free) cellular shade that can easily fit most French doors for $40. Available at Lowe’s. If you need help, we shorten for $25 per window. 1.

You might be interested:  Often asked: How To Remove Adhesive From Plastic Container?

How do you adjust the length of a cordless blind?

These shades work with a lift mechanism either through the headrail or the bottom rail. To adjust, open or close them, you can either lift them or lower them. The bottom rail can be twisted to adjust and open their slats, or a wand can be used to operate them.

Can you take slats out of wooden blinds?

If you already own wood or faux wood blinds that are just too long, sometimes you don’t need to buy new blinds. You can just shorten the ones you already have. Untie the knots and remove the bottom rail of your blind. Now pull up on each lift cord, just enough so you can easily pull out the extra slats.

What are slats on blinds?

Slats are the horizontal pieces that you tilt, raise, and lower when operating your blinds. The difference in slat sizes may not seem like a lot, but the right, or even the wrong, slat size can make a world of difference for your windows.

How do you shorten cordless cellular blinds?


  1. Install cellular shade into your window.
  2. Lower your cellular shade to its longest point.
  3. Decide the desired length of your shade.
  4. Remove both end caps from the bottom of the shade.
  5. Slide the rail off the bottom of the shade.
  6. Unwrap the cords from the bottom of the blind and take off plastic buttons.

Leave a Reply

Your email address will not be published. Required fields are marked *