Readers ask: How To Remove Large Plastic Nut Beneath Toilet Tank?

How do you unscrew a plastic nut that won’t budge?

Whether you use a basin wrench or a hammer and screwdriver, the nut is easier to loosen if you heat it with a hairdryer. The heat should soften the plastic and make the nut pliable enough to break free. It also helps to spray some calcium dissolver on the nut and wait several minutes before tapping or twisting.

How do you unscrew a nut under a toilet bowl?

Remove all the bolts and nuts and then lift the seat off the bowl. Place all of this in the plastic bag, seal it and dispose. If the seat is attached with a traditional metal bolt and metal nut, grab your socket wrench and fit it over the long bolt that grips the nut. Turn the nut counterclockwise to loosen.

How do you unscrew a lock nut?

Share All sharing options for: Loosening a Stuck Nut

  1. Tighten the nut. Moving the nut in any direction is progress.
  2. Tap with a hammer. Jarring the nut can break its bond to the bolt.
  3. Apply heat. Metal expands slightly when hot, which may be enough to crack the nut free.
  4. Soak the nut.
You might be interested:  Question: How To Remove Mold Film From Plastic Blender?

Can you replace toilet bolts without removing toilet?

You can’t replace a closet bolt without removing the bowl. Pull the bowl, and next time pick up brass bolts.

How do you remove a plastic locking nut?

How to Remove a Plastic Lock Nut

  1. Unscrew any fasteners from the bolt on top of the lock nut.
  2. Grip the lock nut in the jaws of pliers or a wrench, and gently turn it counter-clockwise at least one-eighth of a turn.
  3. Grip the loosened lock nut between your thumb and forefinger, and unscrew it all the way.

How do you fix a sticky flush valve?

Either one is usually easy to fix.

  1. Turn off the water valve and hold down the flush handle until the tank is empty.
  2. Adjust the chain holding the flapper to the flush handle.
  3. Clean the inlet holes in the toilet bowl if you can’t stop the flapper from sticking by adjusting the chain.

How do you unscrew a tight plastic lid?

Run hot water over the stuck lid for several minutes to expand the plastic. Firmly grip the lid, and twist it off. Repeat this method if the lid is still stuck. Tap around the edges of the plastic lid with the blunt end of a kitchen knife.

How do you remove a screw with no plastic head?

How to Remove a Screw With No Head

  1. Drill.
  2. Center punch or a hammer and a thin nail.
  3. Drill bits of various sizes.
  4. Easy-out tool.
  5. Pin with a large plastic head.
  6. Wooden dowel to fit the hole.
  7. Glue.

Leave a Reply

Your email address will not be published. Required fields are marked *