Readers ask: How To Remove Plastic Triangle From Dryer Pulley?

How do you change dryer rollers?

Instructions

  1. Shut off the power. Unplug the dryer.
  2. Raise the top panel. Pull the lint screen out of the housing in the top panel of the dryer.
  3. Remove the front panel.
  4. Remove the drum.
  5. Remove the drum support roller.
  6. Install the new drum support roller.
  7. Reinstall the drum.
  8. Reinstall the front panel.

How much does it cost to replace an idler pulley?

There is an average cost for a drive belt idler pulley replacement. Labor costs are between 64 and $81 while parts are between $79 and $83. Taxes and fees are not included in the estimate.

Where is the pulley on a dryer?

The idler pulley is found underneath the drum on the right side of your appliance. As you are reaching under the drum, grab the idler pulley and push down to take the dryer belt off the pulley and the motor shaft. Stand back up, and use the belt to slowly guide the drum out of the dryer.

Should you grease dryer drum rollers?

Dryer drum rollers and pulleys have oil impregnated bushings. They do not need oil. Adding oil will cause more lint/dust to stick to the rollers/shaft and wear the rollers out faster.

You might be interested:  Readers ask: How To Remove Plastic Electrical Insulator?

Why does my dryer sound like it has shoes in it?

Does it sound like you are drying a pair of sneakers or shoes in your dryer? The rumbling or thumping sound could be caused by worn drum support rollers. The drum rollers support the dryer drum on some models and makes of dryers (like those made by Kenmore or Whirlpool.)

What does a bad dryer drum roller sound like?

Noise Cause #2 — Drum Roller Several rollers at the front and rear of most dryers are used to support the drum. After years of use, these rollers can wear out and cause the drum to stop moving freely. A squealing or thumping noise may indicate one or more drum rollers have worn flat, broken, or maybe binding.

Should a dryer idler pulley spin freely?

Spin the pulley wheel. It should turn smoothly and quietly, without any wobble. If your dryer’s idler pulley wheel assembly is damaged, excessively worn, or no longer functioning as it should, it will have to be replaced.

How do you lubricate a idler pulley dryer?

Hold the pulley arm with the shaft pointing upward and apply three or four drops of lightweight household oil to the pulley shaft. Rotate the wheel back and forth to allow the oil to penetrate, then spin the wheel to ensure that it’s turning freely.

How do you fix a pulley on a dryer?

Instructions

  1. Shut off the power. Unplug the dryer.
  2. Raise the top panel. Pull the lint screen out of the housing in the top panel of the dryer.
  3. Remove the front panel.
  4. Remove the idler pulley.
  5. Install the new idler pulley.
  6. Reinstall the front panel.
  7. Reassemble the top panel.
  8. Restore power to the dryer.

Leave a Reply

Your email address will not be published. Required fields are marked *